Polishing

How to give a high-gloss to most of the materials, which can be polished?

TABLE OF RECOMMENDATIONS FOR POLISHING IN 3 STEPS

Steps

Materials >
Recommendations v

Steel, iron, stainless steel and other hard metals

Aluminum,
zamac,
cast iron

Bronze, brass

chromed and nickel-plated pieces

Plastics,
synthetics

1

non-destructive, light abrasion

SISAL +
ALU-SISAL

SISAL +
ALU-SISAL

SISAL +
ALU-SISAL

COTTON +
PEDEU

2

Pre-polishing

COTTON +
RECOR

COTTON +
POLYVAL

COTTON +
PEDEU

COTTON +
RECOR

COTTON +
RECOR

3

High-gloss

COTTON +
EKLA

COTTON +
EKLA

COTTON +
RECOR

COTTON +
EKLA

COTTON +
EKLA

NB.:The state of the to be polished piece will determine the necessary steps. For certain pieces only the third step will be required.

SISAL

Layers of woven SISAL fibres and cotton are assembled with concentric sewings.
Rigid discs, to be used with abrasive paste.

COTTON

Layers of COTTON  are assembled with concentric sewings. «THE MOST CURRENT ONE».
Enables a fine polish of all materials.

FELT

Dense disc, to use with any kind of paste following the required action, to polish small pieces which are often difficult to keep in hand when polishing with cotton.

ALU-SISAL

Abrasive paste to remove scratches, craters, «orange peel» surface, to reduce the roughness.
The obtained finish is mat.

PEDEU

Slightly abrasive paste for pre-polishing bronze, brass, copper. The obtained finish is semi-mat.

POLYVAL

Dry paste to polish aluminum . The obtained finish is bright.

RECOR

For a nice finish of all pieces in brass, bronze, copper,... The obtained finish is bright.

EKLA

The finest paste, to brighten all materials correctly pre-polished.
The obtained finish is «EKLABRIGHT».